Berkeley2006-PromoterMain

From 2006.igem.org

(Difference between revisions)
Jump to: navigation, search
()
 
(12 intermediate revisions not shown)
Line 1: Line 1:
-
'''Isolatation of a family of constitutive promoter parts from a combinatorial library to vary transcription rates'''
+
'''To extend addressable conjugation to a bacterial network, the ability to maintain, send, and receive plasmids must be linked to the transfer of a cognate key sequence in a recipient cellIn this way, whenever a cell recieves a matching key, it becomes activated and responds by sendng a message.'''<br>
-
It is almost always the case that when combining a PoPS signal with an actuation device, such as bacterial conjugation, the rates of transcription and translation must be tuned to match the levels necessary for activation of the device.  In other words, too much protein in the "off" state can lead to a situation where the observed phenotype occurs independent of the key.  Similarly, too little protein in the "on" state can result in a scenario where the bacteria do not conjugate even when the key is presentWhen controlling a gene transcriptionally, this matching of rates can be achieved by manipulating the ribosome binding site of the actuation device.  In translation control, however, the sequence of the ribosome binding site is an essential feature of the mode of regulation and cannot be changed independently. In this scenario, the transcription rate of the device must instead be changed.
+
-
 
+
-
'''The ability to maintain, send, and receive plasmids is lock-controlled'''
+
[[Image:Berkeley2006_Conjugation7.GIF]]
[[Image:Berkeley2006_Conjugation7.GIF]]
-
We thereore developed a set of transcriptional promoter parts that vary the transcription rateThe matching of rates can then be achieved by identifying a promoter providing the proper transcription rate to match the systems requirementsTo make these parts, we adopted a combinatorial approachA synthetic promoter sequence was targetted with saturation mutagenesis employing a binary swap at 8 specific positions within the -10 and -35 sequencesIn this way, 8 positions were simultaneously varied to be either the consensus sequence for that position, or notWe constructed the library fused to an RFP reporter gene containing the strong ribosome binding site b0034, the mRFP 1 gene (E0###), and a double terminator (b0015).  We inserted the 256 member library into the RFP reporter plasmid and picked 96 visibly white colonies and 96 visibly red coloniesThe cells were grown to saturation and then assayed by cytometryFrom this screen, we identified 18 unique promoter variants that each display a different level of fluorescense activity spanning the physiological range between the level observed with cells containing no mRFP gene and values higher than those observed with a Ptet promoter (r0040)These promoter parts will find general use in tuning the expression level of Biobrick devices.  
+
The ability to send messages is linked to the presence of the key by placing critical components of the transfer machinery under lock controlWe have identified the ''traG'' gene of the R system and the ''trbC'' gene of the F system as genes critical for transferWe deleted these genes and observed no transfer of oriT-containing plasmids.  We have contructed Biobrick parts for these genes and are currently constructing locked variants to complement their function.<br>
 +
The ability to maintain a message must similarly be under lock controlWithin a network, cells will be constantly receiving messages, and these plasmids will accumulate if allowed to replicateOur future solution to this problem will employ the R6K/''pir'' systemHere, the protein product of the ''pir'' gene is necessary to replicate plasmids with an R6K origin of replication.  We will place ''pir'' under lock control so that only plasmids containing a cognate key can activate ''pir'' and replicate.<br>
 +
Finally, the ability to receive additional messages will be placed under lock control.  Various genes, including ''dnaB'' are necessary to receive a plasmid by conjugation.  We will place these genes similarly under lock control.
 +
 
 +
=== ===
 +
'''Isolatation of a family of constitutive promoter parts from a combinatorial library to vary transcription rates'''<br>
 +
When placing genes under new regulation, the rates of transcription and translation must be tuned to match the levels necessary for activation of the deviceIn other words, too much protein in the "off" state can lead to a situation where the observed phenotype occurs independently of the keySimilarly, too little protein in the "on" state can result in a scenario where the bacteria do not conjugate even when the key is present.  When controlling a gene transcriptionally, this matching of rates can be achieved by manipulating the ribosome binding site of the gene.  In translation control, however, the sequence of the ribosome binding site is an essential feature of the mode of regulation and cannot be changed independentlyIn this scenario, the transcription rate of the device must instead be changed.
[[Image:Berkeley2006_Promoter.GIF]]
[[Image:Berkeley2006_Promoter.GIF]]
 +
 +
We therefore developed a set of constitutive promoter parts that vary the transcription rate.  The matching of rates can then be achieved by identifying a promoter that satisfies the system's requirements.  To make these parts, we adopted a combinatorial approach.  A synthetic promoter sequence was targetted with saturation mutagenesis employing a binary swap of the -10 and -35 sequences.  Here, 8 positions were simultaneously varied to be either the consensus sequence for that position, or not.  We constructed the library fused to an RFP reporter gene containing a strong ribosome binding site, the mRFP1 gene, and a terminator.  We inserted the 256 member library into the RFP reporter plasmid and picked 96 visibly white colonies and 96 visibly red colonies.  The cells were grown to saturation and then assayed for fluorescence.  From this screen, we identified unique promoter variants (parts J23100-J23119) each displaying a different level of activity spanning the physiological range between the level observed with cells containing no mRFP gene and values higher than those observed with a Ptet promoter (r0040).  Additionally, we constructed the "consensus" promoter basic part, the strongest constitutive promoter.  These parts will find general use in tuning the expression level of Biobrick devices.
----
----
-
Next Section:  [[Berkeley2006-NandMain | Logic Computation in Cellular Networks]]
+
Next Section:  [[Berkeley2006-PlasmidPartsMain | New Biobrick-Compatible Plasmids]]

Latest revision as of 17:17, 30 October 2006

To extend addressable conjugation to a bacterial network, the ability to maintain, send, and receive plasmids must be linked to the transfer of a cognate key sequence in a recipient cell. In this way, whenever a cell recieves a matching key, it becomes activated and responds by sendng a message.

Berkeley2006 Conjugation7.GIF

The ability to send messages is linked to the presence of the key by placing critical components of the transfer machinery under lock control. We have identified the traG gene of the R system and the trbC gene of the F system as genes critical for transfer. We deleted these genes and observed no transfer of oriT-containing plasmids. We have contructed Biobrick parts for these genes and are currently constructing locked variants to complement their function.
The ability to maintain a message must similarly be under lock control. Within a network, cells will be constantly receiving messages, and these plasmids will accumulate if allowed to replicate. Our future solution to this problem will employ the R6K/pir system. Here, the protein product of the pir gene is necessary to replicate plasmids with an R6K origin of replication. We will place pir under lock control so that only plasmids containing a cognate key can activate pir and replicate.
Finally, the ability to receive additional messages will be placed under lock control. Various genes, including dnaB are necessary to receive a plasmid by conjugation. We will place these genes similarly under lock control.

Isolatation of a family of constitutive promoter parts from a combinatorial library to vary transcription rates
When placing genes under new regulation, the rates of transcription and translation must be tuned to match the levels necessary for activation of the device. In other words, too much protein in the "off" state can lead to a situation where the observed phenotype occurs independently of the key. Similarly, too little protein in the "on" state can result in a scenario where the bacteria do not conjugate even when the key is present. When controlling a gene transcriptionally, this matching of rates can be achieved by manipulating the ribosome binding site of the gene. In translation control, however, the sequence of the ribosome binding site is an essential feature of the mode of regulation and cannot be changed independently. In this scenario, the transcription rate of the device must instead be changed.

Berkeley2006 Promoter.GIF

We therefore developed a set of constitutive promoter parts that vary the transcription rate. The matching of rates can then be achieved by identifying a promoter that satisfies the system's requirements. To make these parts, we adopted a combinatorial approach. A synthetic promoter sequence was targetted with saturation mutagenesis employing a binary swap of the -10 and -35 sequences. Here, 8 positions were simultaneously varied to be either the consensus sequence for that position, or not. We constructed the library fused to an RFP reporter gene containing a strong ribosome binding site, the mRFP1 gene, and a terminator. We inserted the 256 member library into the RFP reporter plasmid and picked 96 visibly white colonies and 96 visibly red colonies. The cells were grown to saturation and then assayed for fluorescence. From this screen, we identified unique promoter variants (parts J23100-J23119) each displaying a different level of activity spanning the physiological range between the level observed with cells containing no mRFP gene and values higher than those observed with a Ptet promoter (r0040). Additionally, we constructed the "consensus" promoter basic part, the strongest constitutive promoter. These parts will find general use in tuning the expression level of Biobrick devices.


Next Section: New Biobrick-Compatible Plasmids

Personal tools
Past/present/future years