Lab Notebook

From 2006.igem.org

Revision as of 14:06, 30 May 2006

May 15: Transformed Top10F' bacteria with the pGFP vector containing the Luciferase gene (hopefully the ligation worked this time).17:22, 15 May 2006 (EDT)

May 16: Transformation of Top10F did not work. The cause was an error in the extraction of the DNA from the the agarose gel. Completed a new agarose gel extraction of pGFP plasmid DNA, as cut by EcoRI and HindIII. Prepared a new seed of Top10F bacteria transformed with luciferase. Prepared a midiprep seed of EcoMscL.

May 17: The control of the miniprep? of luciferase was murky. This could have been due to contaminants in the LB, water, ampicillin, or pipet tips. A miniprep of both luciferase and EcoMscL was conducted. A new seed of luciferase was prepared. The miniprep of luciferase was digested with EcoRI and HindIII. The miniprep of EcoMscL was digested with XmnI. A gel with the digests was run but the EcoMscL showed no bands and the luciferase only had faint bands.

May 18: The controls of the seed of luciferase were clear. A miniprep of the new luciferase seed and the old EcoMscL seed was conducted. The same restriction enzymes were used to digest the plasmids. A gel was run with the digests. There were two faint bands on the gel with the EcoMscL when there should have been three. Thus a new batch of Stable 3 bacteria were transformed with EcoMscL through heat shock and plated. The gel with the psp-Luciferase turned out well and the gene was extracted from the gel. Ligation was not completed since the microcentrifuge tube with the pGFP cut vector could not be found due to labelling issues.

May 19: The Stable3 plates were good. We Seeded with 5 microliters of Amp in 2.5mL of LB and 2.5 mL of sterile water and placed in shaker-incubator overnight. We also ligated pGFP & Luciferase (+2 controls, c.f. lab manual) incubating at room temp for 1h. The ligation was then put in the freezer.

May 21: Put up an example of cloning for oscillator.

May 23: A transformation of the luc pGFP ligation product was performed. It was reasoned not to do transfomation on the control (with no ligase) in order to save Top Ten colonies. Also only the transformation of only the ligation with 12 microliters luciferase and 3 microliters pGFP was done, not the 6 microliter luciferase one for the same reason as mentioned above. Only half (10 microliters) of the 12 uL-ligation was used, the rest stored in freezer. The result was plated. Regarding the MSCl, the seeding from the 19th did not work, both the controls were found to be murky (ampicillin and LB as well as LB only) therefore this was performed again.

May 24: 4 or 5 colonies on plates. Seeded 3 colonies in 3 tubes with 5mL LB. [Initially believed there were no colonies and ligation didn't work. We ran a gel of the ligation to see if it contained the Luciferase gene or any DNA at all (since the extraction procedure might not have worked).] It turned out that the Gel was actually fine. There was DNA in the Gel that corresponded to the luciferase insert and the pGFP plasmid. The recombinant plasmid was not seen, but it was not necessary to see it because usually only a small amount of recombination occus. So the plates were re-examined and it was found that on the 150ul plate there were indeed some faint colonies. These colonies were then seeded, 3 colonies and 2 controls picked. Miniprep of Stable 3 bacteria with pB10 vector containing MscL was performed.

May 25: The seeding did not work. It was done again, leaving the pipet tip in the tube. The miniprep product (pB10-MscL) was digested with Xmn1 and gel was run, to check the identity of the DNA. 3 new ligations of pGFP-Luciferase were performed: 1uL-vector/15uL-insert ; 1,32/4,43 ; 4/12. -15:00, 25 May 2006 (EDT)The Gel Showed absolutely nothing, the laddder was smeared and there was no DNA in the lane.

May 26: It was found that there was nothing in the seeding, as well the new ligations/transformations did not work. Worked on midi-prep of MSCL and digested luciferase and GFP with same enzymes: EcoRI and Hind III. Ran digests on a gel and got two very faint bands in wells 5, 6 and 7 for luciferase plasmid and gene but no bands in wells 2, 3 and 4 for GFP. Cut out luciferase gene and put gel in two tubes in freezer labeled "luc insert" with the date. WE think the reason there was no GFP is because we may have cut the insert instead of the plasmid because we used GFP DNA from May 16th, DNA which could not be identified as to whether it was the whole plasmid or just the GFP gene. Decided to make a square table to increase organization and to avoid confusion. Adopted new labeling technique where paper boxes correspond to actual boxes in freezer. Everytime we put something in the freezer, we indicate on paper in the appropriate box what we put there (name of plasmid), when (date) and who did it (first name). Now a message from Horia about tomorrow's fundraising party: Hey guys I just want to say that I won't be able to come in today, I still have to run some errands for the party tomorrow. Ashwin, can you bring my notebook tomorrow? And Ashwini, are you still interested in crafting a donation box? And who wanted to make snacks/brownies/cookies again? Just let me know by email or phone, so i get this organized - in my head at least:) Horia 12:07, 26 May 2006 (EDT)

May 29:Goals for this week: produce and screen midipreps of pGFP and EcoMscL. Grow a batch of chemically competent BL21 (mscl-) E. coli. Prepare minimal medium and thin imaging coverslips. Transfect cells with pGFP and image/photograph the fluorescence (can we see them moving? Do we need a video camera?) Organize plasmids and cloning fragments. Determine schedules and communication strategy for cloning. Belinda and Juilia prepared minimal medium solutions. Aaron and Brock ran a gel on the digest for MSCL but there was no DNA seen. The Bio bricks are finally in!!!! Ashwin and Adam did midiprep of pGFP and got a nice pellet. Also did 2 small-scale seedings of MscL, one from Stable3 cells and the other from DH5a.

May 30: We will have an ORGANISATION MEETING at 12pm in the B floor conference room. Coffee, tea and cookies will be served. PLEASE be there, because we need everyone to help in keeping things organised. If you REALLY can't make it, I will send you minutes of the meeting, but it is critical to have everyone start out on the same wavelength.